GPS - Cross Slope: The grader has cross slope installed which is controlled from the monitor on the r/h cab panel. The tag on the wiring harness has Trimble on it so I suspect it’s partly an aftermarket fitment
ENGINE - Oil or fuel leaks: Good
ENGINE - General running Condition: Ok
DRIVE TRAIN - Transmission: Ok
DRIVE TRAIN - Front axle: ok
DRIVE TRAIN - Differential rear: Ok
DRIVE TRAIN - Final drives: Ok
DRIVE TRAIN - General condition, any other comments: No torque converter fitted to this machine
HYDRAULICS - Pumps: Ok
HYDRAULICS - Hdraulic motors: Ok
HYDRAULICS - Valves: Ok
HYDRAULICS - Hydraulic tank: Ok
HYDRAULICS - Hoses: Ok
HYDRAULICS - Cylinders: Ok
HYDRAULICS - Auxiliary hyd's: Ok
HYDRAULICS - General condition of hyd's: Ok
CAB - Back up alarm: Ok
CAB - Battery isolator switch: ok
CAB - Lights: Ok
CAB - Wipers: Ok
CAB - Heater: Ok
CAB - A/C: Ok
CAB - Seat condition: Ok
CAB - Cladding condition: Ok
CAB - Floor mat condition: Ok
CAB - Seat belt: Ok
CAB - Mirrors: Ok
CAB - Horn: Ok
CAB - Steps and grab handles secure?: Ok
BLADE - Type: Serated. Width: 12'. Height: 24"
BLADE - Cutting edges condition: NEW
BLADE - Linkage on back of blade: Good
BLADE - Turntable and drive sprocket, are there shims: Good
BLADE - General blade condition: Good
PANELS & PAINT / DECALS - Any damage to panels: Minor cosmetic relating to hours
PANELS & PAINT / DECALS - Paint condition: Ok
PANELS & PAINT / DECALS - Any decals ripped: No
TYRES - L/H front: 50% No damage
TYRES - R/H Front: 50% No damage
TYRES - L/H Rear front: 50% No damage
TYRES - R/H Rear front: 50% No damage
TYRES - L/H Rear back: 50% No damage
TYRES - R/H Rear back: 50% No damage
Has Trimble GPS Wiring
New Cutting Edge Fitted